ASR Forum

Eu zic sa nu sariti la GBB ieftine, cel putin nu la AGM.
.... m-am documentat mai bine, am aflat ca hop-upul ori nu functioneaza, ori sare des, incarcatorul de 700g stock in 80% din cazuri pierde gaz, iar precizia lasa de dorit...

Deschide-le o disputa cu paypal daca ai trimis banii cu paypal. Sau macar ameninta-i ca asta le faci. Spune-le ca e inacceptabil ca ei sa primeasca banii pentru un produs si sa nu-l livreze. Ameninta-i eventual ca o sa iei toate masurile legale care-ti stau in putere sa-ti recuperezi banii. Spune-le ca store credit nu e acceptabil si ca tu nu ai cumparat store credit de la ei ci anumite produse. Asa ca ori iti returneaza banii pe produsele neprimite si partea de shipping aferenta conform shipping calculator-ului, ori le deschizi disputa paypal si le ceri toti banii inapoi si eventual ii dai si-n judecata pentru neonorarea comenzii.

Mda, mi-ati cam dat emotii, astept un AGM de la ehobby, sper din tot sufletul sa nu ajung in aceeasi situatie

The gun the BB is fired from is irrelevant. Once the BB leaves the barrel, it has no memory of the gun it was fired from.

***Before you perform this mod make sure that the bolt catch in the lower reciever moves freely without getting stuck. It has to be smooth and I do recommend that you spray a bit of silicone oil to allow it to move freely. If it still doesn't move smoothly, file or sand down the little channel where the bolt catch sits.***

Here's my guide on how to make the magazine spring stiffer. This will allow the lever on your magazine to push up on the bolt stop with enough force to lock the bolt back 100% of the time. Before starting the mod, feel the pressure of the lever that pushes up on the bolt catch, feel it again after you're done.

Items needed:



-8 BBs
-1/16'' Pin Punch
-AGM M4 GBB Magazine
-Hammer

Step #1:

Locate the 4 pins that hold the BB channel in place.



Step #2:

Use the punch and hammer to push the pins out of the magazine body.



Step #3:

Dislodge the plastic BB channel from the magazine body and pull out the spring and its tracer:



Step #4:

Put 8 BBs down the magazine's BB "tunnel". It's the tunnel like opening in lower part of the magazine. Put the BBs in by 2's, double stacked.







Step #5:

Place the spring and the tracer back in. Make sure to grasp the spring to prevent it from springing everywhere since it will be significantly harder to put back in. While holding the spring down put the plastic BB channel back on. Make sure it clicks back onto the magazine body, with the two little prongs on the bottom facing down.





Step #6:

Push the pins back into the magazine and you're done!



This mod will allow your bolt to lock back 100% of the time when the magazine is empty. Both on semi and on full auto. Before the mod if you wanted to dry fire without having the bolt lock back all you had to do was flip the little switch on top of the mag. With this mod you will have to first press and hold down the black lever located in the upper back of the mag and then flip the little switch since the stiffer pressure won't let the switch work on its own.

With this mod the magazine now holds a total of 50 BBs(it also shoots out all of them). The bolt also locks back flawlessly when the magazine is empty.